How to safely remove paint from an aluminum Boat.? - spray paint aluminum boat
Not sure if I sand, I do not think so. Is there a stripper that I buy that are not eaten, the aluminum can? I was also always in the aluminum boat with Bedliner Truck, white, natural spray. Is this a bad idea? The boat is old and Dura-Craft V-14-foot aluminum hull. Thank you for your time and interest on this subject.
Monday, December 7, 2009
Spray Paint Aluminum Boat How To Safely Remove Paint From An Aluminum Boat.?
Subscribe to:
Post Comments (Atom)
2 comments:
Soda or ice blasting is very sure that the alloy, very effective and gives the best possible start for A1, a painting - but not cheap.
There are many strippers who find no effect on the alloy, even when you're finished, two packages are much more difficult to attack chemically. If you have a double packaging in good condition are better able Getting Any repair, sanding smooth, with no special primers allies too many high-build epoxy primer and a couple of layers of two parcels of record of long-term solution. These products require a professional attitude and safety equipment to use at any time.
Bedliner Alloy in a boat, you see, and seems to be profitable - but corrosion can occur under which it requires a lot of work still trying to adjust to. Accession to the correct alloy is, without burning and booting difficult, and once this is done and can work properly to an end. A similar preparation and processing, the body type a much longer term solution. Here's a tip of Commerce - is the use of sugar liberally to take the final layer on the inside of two packages. Sprinkle the surface is fully cured, if the sugar dissolves and can be a very effective, but gentle on clothes and knees adhesive surface. The degree of sugar makes the grip a fine or course.
Good luck.
If you Google search for "aircraft stripper" is much more information about this separator designed to remove aluminum color. There are several manufacturers and some environmentally friendly products.
Bedliners online plants were used alum. Ships in the past. If this is the look you want, then there should be no problem. Coatings are generally smooth or rough to finish.
when working with chemical strippers that you have all precautions, including gloves, followed by resistance to chemicals. I had good results by my boat on a large poly (blue or gray), on the screen, take the rest of old paint. This makes cleaning easier. You can also use plastic scraper to remove the color removed (to avoid scratching the alum. Hull)
Hope this helps
Post a Comment